Revision as of 11:19, 12 July 2017

The goal of the modular aerogel RICH (mRICH) is to provide hadronic PID capability with momentum coverage from 3 to 10 GeV/c with a compact design in order to overcome the space limitations of the EIC experiments. Although the multi-layer proximity-focusing RICH design, such as ARICH at BELLE2, can achieve three-sigma K/π separation at 4 GeV/c, a larger expansion volume is required for PID in higher momentum range.

A multi-layer proximity-focusing RICH design increases PID separation power by increasing number of detected photons (Nγ) by adding successive layers of radiator while keeping the uncertainty of Cherenkov angle (σ_θ) of single photon measurement. In contrast, the novel lens-based mRICH design improves the separation power by minimizing the uncertainty σ_θ as a result of lens focusing, as shown in Figure 2.3.1 (right), which also requires a smaller coverage of the photosensor plane.

Detector Design

Figure 1.1 (a). Modular RICH detector in GEMC simulation	Figure 1.1 (b). Single 9 GeV/c pion simulation

Figure 1.2. Lens focusing gives thinner Cherenkov ring image compare to BELLE-2 ARICH design (below)

Figure 1.3. BELL-2 ARICH design a double layer proximity focusing RICH detector. By using two different refractive indices aerogel block, in order to increase number of photons detected while keeping uncertainty of single photon measurement.

Figure 1.4. When the charge particle incident along the z-axis of the detector, Cherenkov ring image from the incident particle will be shifted to the central area of the sensor plane, resulting fewer photon loss, and reduce image distortion.

Figure 1.5. Cherenkov ring image from particles that are incident at the third quadrant of the detector.

Figure 1.6. Separation power of modular RICH detector obtained from simulation using 6" focal length Fresnel lens with different pixel sizes

Fisrt Prototype and Beam Test

Figure 2.1. First mRICH prototype

Beam test set up at Fermilab Test Beam Mtest Facility for the first modular RICH prototype detector is shown in the picture below. The detector (black box) sit at the center of a aluminium frame. On both ends of the aluminium frame are hodoscopes. Each hodoscopes consist of four horizon finger-size (1cm x 1cm) scintillators, and four vertical finger-size scintillators. On the far right of the aluminium frame was trigger paddle. The beam was coming from right to left of the picture.

Figure 3.1. Beam test set up at Fermilab Test Beam Mtest Facility for the first modular RICH prototype detector.

Accumulated hit maps from test beam data (right) and simulation (left) are shown in figure (3.2) and (3.3).

Figure 3.2. Test beam (left) and simulation (right) results from 120 GeV/c proton beam hit perpendicularly at the center of detector xy plane

Figure 3.3. Test beam (left) and simulation (right) results from 120 GeV/c proton beam hit perpendicularly at the 3rd quadrant of detector xy plane.

Second Prototype

Figure 3.2. (left) 3D drawing of the second mRICH prototype. (right) construction of the second mRICH prototype.

mRICH Detector System Simulation

• sPHENIX/ePHENIX
• JLEIC